Wir haben dieses praktische Glossar aufgenommen, um Sie bei Terminologie und Abkürzungen in Bezug auf Stromprodukte zu unterstützen. Wählen Sie einen der folgenden Buchstaben oder laden Sie das Glossar herunter, um jederzeit darauf zugreifen zu können.A B C D E F G H I J K L M N O P Q R S T U V W X-Z #
Abbreviation for volt.
Abbreviation for volt-ampere.
Combination of Variable Resistor. A two-electrode semiconductor device having a non-linear, voltage-dependent resistance (usually a high resistance at low voltages and low resistance at high voltages). Often used to protect circuits against transient voltages.
The process of dipping a transformer or coil in varnish to bind or protect materials.
Voltage Collector Collector. Positive supply voltage of a Bipolar Junction Transistor. The doubled suffix indicates that the voltage is common. i.e. it is the supply voltage to one (or more) collectors and not just the voltage at a specific collector.
Voltage Drain Drain. Positive supply voltage of a Field Effect Transistor. The doubled suffix indicates that the voltage is common. i.e. it is the supply voltage to one (or more) drains and not just the voltage at a specific drain.
Abbreviation for Verband Deutscher Elektrotechniker.
Abbreviation for Voltage Dependent Resistor.
Voltage Emitter Emitter. Negative supply voltage of a Bipolar Junction Transistor. The doubled suffix indicates that the voltage is common. i.e. it is the supply voltage to one (or more) emitters and not just the voltage at a specific emitter.
German organisation charged to test and to evaluate products, including power sources. See http://www.vde.com/vde_en/
See Plated Through Hole.
Unit of measurement of electromotive force or potential difference. Symbol E, in electricity; symbol V in semiconductor circuits. A current of 1 A passing through a resistance of 1 ohm will produce a potential difference of 1 volt. See Ohm's Law. Written as 'volt'. Abbreviated to V.
Rate of change of voltage over a period of time expressed in volts/microseconds.
In a control circuit, the on-time x the voltage applied to the winding is controlled (effectively running the magnetic component at peak magnetic flux density).
A circuit in the control of the pulse width modulator located in the primary which terminates the pulse when the volt seconds applied to the primary of the transformer exceeds a predetermined value.
A derivative electrical quantity, E, measured in the units volts and defined in terms of the independently obtained ampere, I, and the unit or Resistance, ohm (R) by Ohm’s Law E=IR.
The difference in magnitude, in percent, between differential tracking output voltages of a power supply (PSU) where the voltages have equal nominal values with opposite polarities.
See Clamp Circuit
Another name for Varistor.
Tapped or series resistance or impedance across a source voltage to produce a lower output voltage.
Difference in potential between two points in a passive component or circuit.
Maximum or minimum value in a voltage range.
Bounding circuit used to set specified maximum or minimum voltage levels.
The process of holding voltage constant between selected parameters, the extent of which is expressed as a percent. See also Regulation.
A power source that delivers constant voltage.
The use of a circuit or device to hold an output voltage constant within given limits.
Unit of Apparent Power.
Voltage Source Source. Negative supply voltage of a Field Effect Transistor. The doubled suffix indicates that the voltage is common. i.e. it is the supply voltage to one (or more) sources and not just the voltage at a specific source.A B C D E F G H I J K L M N O P Q R S T U V W X-Z #